Subaru Legacy 2002 Service Manual page 1713

Manual Transmission and Differential
10) Install roller bearing onto drive pinion.
NOTE:
When installing roller bearing, note its directions
(front and rear) because knock pin hole in outer
race is offset.
(A) Roller bearing
(B) Knock pin hole
11) Install washer using ST1, ST2 and press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
ST1 499277100 BUSH 1-2 INSTALLER
ST2 499277200 INSTALLER
(A) Washer
12) Install thrust bearing and needle bearing.
Install driven shaft assembly.
DRIVE PINION SHAFT ASSEMBLY
B3M1661A
B3M0080E
B3M0082
MT-88
13) Install drive pinion collar, needle bearing,
adjusting washer No. 2, thrust bearing, adjusting
washer No. 1 and differential bevel gear sleeve in
that order.
NOTE:
Be careful because spacer must be installed in
proper direction.
(A) Driven shaft
(B) Drive shaft
(C) Drive pinion collar
Needle bearing (25 × 30 × 20)
(D)
Washer No. 2 (25 × 36 × 4)
(E)
Thrust bearing (25 × 37.5 × 3)
(F)
(G) Washer No. 1 (25 × 36 × t)
(H) Differential bevel gear sleeve
E: INSPECTION
Disassembled parts should be washed clean first
and then inspected carefully.
1) Bearings
Replace bearings in the following cases:
¼ Bearings whose balls, outer races and inner
races are broken or rusty.
¼ Worn bearings
¼ Bearings that fail to turn smoothly or make
abnormal noise when turned after gear oil lubrica-
tion.
B3M0083D
S503269A10