Front Abs Sensor - Subaru Legacy 2002 Service Manual

ABS

4. Front ABS Sensor

A: REMOVAL
S401190A18
1) Disconnect battery ground cable.
2) Disconnect front ABS sensor connector located
next to front strut mounting house in engine com-
partment.
3) Remove bolts which secure sensor harness to
strut.
4) Remove bolts which secure sensor harness to
body.
(1) To front ABS sensor connector
(2) Bracket
5) Remove bolts which secure front ABS sensor to
housing, and remove front ABS sensor.
CAUTION:
¼ Be careful not to damage pole piece located
at tip of the sensor and teeth faces during
removal.
¼ Do not pull sensor harness during removal.
FRONT ABS SENSOR
B: INSTALLATION
S401190
1) Temporarily install front ABS sensor on hous-
ing.
CAUTION:
Be careful not to strike ABS sensor's pole
piece and tone wheel's teeth against adjacent
metal parts during installation.
B4M1442
2) Install front ABS sensor on strut and wheel
apron bracket.
Tightening torque:
B4M1728C
B4M2209
ABS-12
32 N·m (3.3 kgf-m, 24 ft-lb)
(1) To front ABS sensor connector
(2) Bracket
S401190A11
B4M2209
B4M1728C