Subaru Legacy 2002 Service Manual page 1641

Manual Transmission and Differential
C: CAUTION
S503001A03
¼ Wear working clothing, including a cap, protec-
tive goggles, and protective shoes during opera-
tion.
¼ Remove contamination including dirt and corro-
sion before removal, installation, and disassembly.
¼ Keep the disassembled parts in order and pro-
tect them from dust or dirt.
¼ Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary
removal, installation, disassembly and replace-
ment.
¼ When disassembling the case and other light
alloy parts, use a plastic hammer to force it apart.
Do not pry it apart with a screwdriver or other tool.
¼ Be careful not to burn your hands, because each
part on the vehicle is hot after running.
¼ Use SUBARU genuine gear oil, grease etc. or
the equivalent. Do not mix gear oil, grease etc. with
that of another grade or from other manufacturers.
D: PREPARATION TOOL
1. SPECIAL TOOLS
ILLUSTRATION
B3M1938
B3M1939
GENERAL DESCRIPTION
S503001A17
S503001A1701
TOOL NUMBER
398791700 REMOVER II
399411700 ACCENT BALL
INSTALLER
¼ Be sure to tighten fasteners including bolts and
nuts to the specified torque.
¼ Place shop jacks or safety stands at the speci-
fied points.
¼ Apply gear oil onto sliding or revolution surfaces
before installation.
¼ Replace deformed or otherwise damaged snap
rings with new ones.
¼ Before installing O-rings or oil seals, apply suf-
ficient amount of gear oil to avoid damage and
deformation.
¼ Be careful not to incorrectly install or fail to install
O-rings, snap rings and other such parts.
¼ Before securing a part on a vise, place cushion-
ing material such as wood blocks, aluminum plate,
or shop cloth between the part and the vise.
¼ Avoid damaging the mating surface of the case.
¼ Before applying sealant, completely remove the
old seal.
DESCRIPTION
Used for removing and installing spring pin (6
mm).
Used for installing reverse shifter rail arm.
MT-16
REMARKS