Subaru Legacy 2002 Service Manual page 2292

ST1 92511000 PRESSURE GAUGE
ST2 34099AC020 ADAPTER HOSE B
ST3 34099AC010 ADAPTER HOSE A
(2) Disconnect pressure hose from the pump.
(3) Using gasket (Part No. 34621AC021) and
bolt (Part No. 34620AC010), instal ST2 to the
pump instead of pressure hose.
Except 3.0 L model:
(1) Suction hose
(2) Pressure hose
3.0 L model:
(1) Suction hose
(2) Pressure hose
(4) Disconnect pipe C form pipe (on gearbox
side).
(5) Install ST3 to pipe C.
(1) Pipe C
(2) Pipe D
(6) Replenish power steering fluid up to speci-
fied level.
OIL PUMP
(7) Open valve, and start the engine.
(8) Measure regular pressure.
ST1 925711000 PRESSURE GAUGE
ST2 34099AC020 ADAPTER HOSE B
ST3 34099AC010 ADAPTER HOSE A
Service limit:
B4M1659B
981 kPa (10 kg/cm
(9) If it is not within the specified value, replace
the troubled part caused by the following symp-
toms; pipe or hose clogged, leaks from fluid line,
and mix of foreign objects in fluid line.
2) Measure relief pressure.
(1) Using STs, measure relief pressure.
(2) Close valve.
(3) Measure relief pressure.
ST1 925711000 PRESSURE GAUGE
ST2 34099AC020 ADAPTER HOSE B
ST3 34099AC010 ADAPTER HOSE A
B4M2435A
Service limit:
Except 3.0 L model
9,611 — 10,199 kPa (98 — 104 kg/cm
1,394 — 1,479 psi)
3.0 L model
7,650 — 8,340 kPa (78.03 — 88.13 kg/cm
1,109 — 1,209 psi)
B4M1696B (4) If it is not within the specified value, replace
the oil pump.
PS-83
Power Assisted System (Power Steering)
2
, 142 psi) or less
B4M1675A
B4M1676A
2
,
2
,