Subaru Legacy 2002 Service Manual page 2207

Parking Brake
B: INSTALLATION
CAUTION:
Be sure lining surface is free from oil contami-
nation.
Brake grease:
Dow Corning Molykote No. 7439 (Part No.
725191460)
1) Apply brake grease to the following places.
¼ Six contact surfaces of shoe rim and back plate
packing
¼ Contact surface of shoe wave and anchor pin
¼ Contact surface of lever and strut
¼ Contact surface of shoe wave and adjuster
assembly
¼ Contact surface of shoe wave and strut
¼ Contact surface of lever and shoe wave
2) Install in reverse order of removal.
CAUTION:
¼ Use new retainers and clinch them when
installing brake shoes to levers.
¼ Ensure that parking lever moves smoothly.
¼ Do not confuse left parking lever with right
one.
¼ Do not confuse left strut with right one.
NOTE:
Ensure that adjuster assembly is securely installed
with screw in the left side, facing vehicle front.
(1) LEFT
PARKING BRAKE ASSEMBLY
S404169A11
S4M0461A
NOTE:
Ensure that shoe return spring is installed as
shown in Figure.
(1) Back plate
(2) Shoe guide plate
(3) Retainer
(4) Spring washer
(5) Lever
(6) Primary shoe return spring (Blue)
(7) Secondary shoe return spring (Yellow)
(8) Parking brake shoe (Primary)
(9) Parking brake shoe (Secondary)
3) Adjust parking
ADJUSTMENT, Parking Brake Assembly.>
CAUTION:
After replacing parking brake lining, be sure to
drive vehicle for "break-in" purposes.
(1) Drive the vehicle about 35 km/h (22 MPH).
(2) With the parking brake release button
pushed in, pull the parking brake lever gently.
(3) Drive the vehicle for about 200 meter (0.12
mile) in this condition.
(4) Wait 5 to 10 minutes for the parking brake
to cool down. Repeat this procedure once
more.
(5) After breaking-in, re-adjust parking brakes.
PB-8
S4M0462A
brakes. <Ref. to PB-9,