Subaru Legacy 2002 Service Manual page 2078

D: ASSEMBLY
S301156A02
CAUTION:
Use specified grease.
BJ side:
Molylex No. 2 (Part No. 723223010)
DOJ side:
VU-3A702 (Yellow) (Part No. 23223GA050)
1) Install BJ boot in specified position, and fill it
with 60 to 70 g (2.12 to 2.47 oz) of specified
grease.
2) Place DOJ boot at the center of shaft.
CAUTION:
Be sure to wrap shaft splines with vinyl tape to
prevent boot from scratches.
3) Insert DOJ cage onto shaft.
NOTE:
Insert the cage with the cut-out portion facing the
shaft end, since the cage has an orientation.
(A) Cage
(B) Cut-out portion
4) Install DOJ inner race on shaft and fit snap ring
with pliers.
NOTE:
Confirm that the snap ring is completely fitted in the
shaft groove.
REAR DRIVE SHAFT
5) Install cage, which was previously fitted, to
inner race fixed upon shaft.
NOTE:
Fit the cage with the protruded part aligned with the
track on the inner race and then turn by a half
pitch.
(A)
(B)
6) Fill 80 to 90 g (2.82 to 3.17 oz) of specified
grease into the interior of DOJ outer race.
7) Apply a coat of specified grease to the cage
pocket and six balls.
8) Insert six balls into the cage pocket.
9) Align the outer race track and ball positions and
place in the part where shaft, inner race, cage and
balls are previously installed, and then fit outer
race.
S4M0376B
(A)
(B)
G4M0285
DS-33
Inner race
Cage
Outer race
Grease
Drive Shaft System
B4M0228E
B4M0227E