Subaru Legacy 2002 Service Manual page 2477

VDC (Diagnostics)
7. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
S005503A1601
1) Prepare Subaru Select Monitor kit.
2) Connect diagnosis cable to Subaru Select
Monitor.
3) Insert cartridge into Subaru Select Monitor.
<Ref. to VDC-9, SPECIAL TOOLS, PREPARA-
TION TOOL, General Description.>
4) Connect Subaru Select Monitor to data link
connector.
(1) Data link connector located in the lower por-
tion of the instrument panel (on the driver's
side).
(1) Data link connector
(2) Connect diagnosis cable to data link con-
nector.
SUBARU SELECT MONITOR
S005503
S005503A16
S2M0285
S2M0286
B2M2960G
5) Turn ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(1) Power switch
6) On the Main Menu
the {Each System Check} and press the [YES] key.
7) On the System Selection Menu
screen, select the {Brake Control System} and
press the [YES] key.
8) Press the [YES] key after displayed the infor-
mation of engine type.
9) On the Brake Diagnosis
select the {Diagnostic Code(s) Display} and press
the [YES] key.
10) On the Diagnostic Code(s) Display
screen, select the {Current Diagnostic Code(s)} or
{History Diagnostic Code(s)} and press the [YES]
key.
NOTE:
¼ For detailed operation procedure, refer to the
SUBARU SELECT
MANUAL.
¼ For detailed concerning diagnostic trouble
codes, refer to the DIAGNOSTIC TROUBLE
CODE LIST.
<Ref. to VDC-26, List of Diagnostic Trouble Code
(DTC).>
¼ A maximum of 3 trouble codes are displayed in
order of occurrence.
*a* refers to the troubles in order of occurrence
(Latest, Old, Older).
VDC-18
S2M0288D
display screen, select
display
display screen,
display
MONITOR OPERATION
B4M2173A