Subaru Legacy 2002 Service Manual page 2068

B: INSTALLATION
1) Align hub unit bearing with back plate at mount-
ing holes and install hub unit assembly and back
plate. Temporarily tighten axle nuts.
CAUTION:
Be careful not to damage tone wheel.
2) Tighten four bolts to back plate.
3) Remove axle nut.
4) Using ST1 and ST2, pull axle shaft into place.
ST1 922431000 AXLE SHAFT INSTALLER
ST2 927390000 ADAPTER
5) Temporarily tighten axle nuts.
6) Install disc rotor on hub.
HUB UNIT BEARING
S301155A11
B4M1711
B4M1682
B4M1690A
DS-23
7) Install disc brake caliper on back plate.
Tightening torque:
52 N·m (5.3 kgf-m, 38.3 ft-lb)
8) Install rear ABS sensor and brake cable
bracket.
9) Adjust parking brake lever stroke by turning
adjuster. <Ref. to PB-4, ADJUSTMENT, Parking
Brake Lever.>
10) Move brake lever back to apply brakes. While
depressing brake pedal, tighten axle nut using a
socket wrench. Lock axle nut after tightening.
Tightening torque:
186 N·m (19 kgf-m, 137 ft-lb)
Drive Shaft System
B4M1710
B4M1679