Subaru Legacy 2002 Service Manual page 2065

Drive Shaft System
2) Using a hydraulic press, press new hub bolts
into place.
CAUTION:
Be sure to press hub bolts until their seating
surfaces contact the hub.
NOTE:
Use 12 mm (0.47 in) dia. holes in HUB STAND to
prevent bolts from tilting.
3) Clean dust or foreign particles from inside the
housing.
4) Using ST1 and ST2, press a new bearing into
place.
ST1 927400000 HOUSING STAND
ST2 927100000 BEARING REMOVER
CAUTION:
¼ Always press outer race when installing
bearing.
¼ Be careful not to remove plastic lock from
inner race when installing bearing.
¼ Charge bearing with new grease when outer
race is not removed.
Specified grease:
SHELL 6459N
5) Using pliers, install snap ring in its groove.
CAUTION:
Make sure to install it firmly to groove.
FRONT AXLE
6) Using ST1 and ST2, press inner oil seal until it
contacts circlip.
ST1 927410000 OIL SEAL INSTALLER
ST2 927400000 HOUSING STAND
7) Invert ST and housing.
ST 927400000 HOUSING STAND
8) Using ST1 and ST2, press outer oil seal until it
contacts the bottom of housing.
ST1 927410000 OIL SEAL INSTALLER
ST2 927400000 HOUSING STAND
9) Apply sufficient grease to oil seal lip.
Specified grease
G4M0232
SHELL 6459N
CAUTION:
¼ If specified grease is not available, remove
bearing grease and apply Auto Rex A instead.
¼ Do not mix different types of grease.
10) Install disc cover to housing the three bolts.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
11) Attach hub to ST1 securely.
12) Clean dust or foreign particles from the pol-
ished surface of hub.
G4M0226
DS-20
G4M0234
G4M0233