Subaru Legacy 2002 Service Manual page 2521

DIAGNOSTICS CHART WITH DIAGNOSIS CONNECTOR
VDC (Diagnostics)
No.
16 CHECK SHIELD CIRCUIT.
1) Connect all connectors.
2) Measure resistance between shield con-
nector and chassis ground.
Connector & terminal
DTC 22 / (B62) No. A5 — Chassis
ground:
DTC 24 / (B62) No. A6 — Chassis
ground:
NOTE:
For the DTC 26 and 28, Go to step 17.
17 CHECK VDCCM.
1) Connect all connectors.
2) Erase the memory.
3) Perform inspection mode.
4) Read out the diagnostic trouble code.
18 CHECK ANY OTHER DIAGNOSTIC
TROUBLE CODES APPEARANCE.
Step
Is the resistance less than
0.5 Ω?
Is the same diagnostic
trouble code as in the cur-
rent diagnosis still being
output?
Are other diagnostic trouble
codes being output?
VDC-62
Check Yes
Go to step 17.
Replace VDCCM.
<Ref. to VDC-9,
VDC Control Mod-
ule (VDCCM).>
Proceed with the
diagnosis corre-
sponding to the
diagnostic trouble
code.
No
Repair shield har-
ness.
Go to step 18.
A temporary noise
interference.