Control Valve Body - Subaru Legacy 2002 Service Manual

16. Control Valve Body

A: REMOVAL
S502564A18
1) Lift-up the vehicle.
2) Clean transmission exterior.
3) Drain ATF completely.
NOTE:
Tighten ATF drain plug after draining ATF.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(A) Oil pan
(B) Drain plug
(C) Differential oil drain plug
4) Remove the oil pan.
NOTE:
¼ Remove and clean the magnet.
¼ Remove the old gasket on the oil pan and trans-
mission case completely.
CONTROL VALVE BODY
5) Disconnect duty solenoids and ATF tempera-
S502564
ture sensor connectors. Remove connectors from
clip and disconnect connectors.
B3M1036B
6) Remove the control valve.
NOTE:
When removing control valve body, be careful not
to interfere with transfer duty solenoid wiring.
AT-39
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Transmission ground
Automatic Transmission
B2M2263I
B3M1037