Subaru Legacy 2002 Service Manual page 2164

6) Remove lock pin boot and guide pin boot.
D: ASSEMBLY
S405176A02
1) Clean caliper body interior using brake fluid.
2) Apply a coat of brake fluid to piston seal and fit
piston seal in groove on caliper body.
3) Apply a coat of brake fluid to the entire inner
surface of cylinder and outer surface of piston.
4) Insert piston into cylinder.
CAUTION:
Do not force piston into cylinder.
5) Apply a coat of specified grease to boot and fit
in groove on ends of cylinder and piston.
Grease:
NIGLUBE RX-2 (Part No. 003606000)
To facilitate installation, fit boot starting with piston
end.
(1) Piston boot
(2) Boot ring
(3) Piston seal
(4) Caliper body
6) Position boot in grooves on cylinder and piston.
7) Install boot ring. Be careful not scratch boot.
FRONT DISC BRAKE ASSEMBLY
B4M0771
S4M0448A
BR-25
8) Apply a coat of specified grease to lock pin and
guide pin, outer surface, cylinder inner surface,
and boot grooves.
Grease:
NIGLUBE RX-2 (Part No. 003606000)
(1) Pin boot
(2) Lock pin or guide pin
(3) Apply grease.
9) Install lock pin boot and guide pin boot on sup-
port.
E: INSPECTION
1) Repair or replace faulty parts.
2) Check caliper body and piston for uneven wear,
damage or rust.
3) Check rubber parts for damage or deterioration.
Brake
B4M1176B
S405176A10