Subaru Legacy 2002 Service Manual page 1613

SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
Automatic Transmission
17. Shift Solenoids, Duty
Solenoids and ATF
Temperature Sensor
A: REMOVAL
S502227A18
1) Lift-up the vehicle.
2) Clean transmission exterior.
3) Drain ATF completely.
NOTE:
Tighten ATF drain plug after draining ATF.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(A) Oil pan
(B) Drain plug
4) Remove oil pan.
5) Disconnect solenoid and sensor connectors.
Remove connectors from clip and disconnect con-
nectors.
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
S502227
B3M1036C
B2M2263J
AT-42
6) Remove solenoids, duty solenoids and ATF
temperature sensor.
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
1. TRANSFER DUTY SOLENOID AND
TRANSFER VALVE BODY
1) Set up the vehicle on a lift.
2) Disconnect battery ground cable.
3) Remove air cleaner case or air intake chamber.
Except 3.0 L model
<Ref. to IN-6, INSTALLATION, Air Cleaner Case.>
3.0 L model
<Ref. to IN(H6)-6, INSTALLATION, Air Intake
Chamber.>
4) Remove pitching stopper.
5) Remove front exhaust pipe with center exhaust
pipe.
Except 3.0 L model
<Ref. to EX(w/oOBD)-9,
Exhaust Pipe.> or <Ref. to EX-5, REMOVAL, Front
Exhaust Pipe.>
3.0 L model
<Ref. to EX(H6)-5, REMOVAL, Front Exhaust
Pipe.>
6) Remove rear exhaust pipe and muffler.
Except 3.0 L model
B3M1039A
S502227A1801
H3M1839
REMOVAL, Front