Subaru Legacy 2002 Service Manual page 2202

2. PARKING BRAKE CABLE
(1) Parking brake lever
(2) Parking brake switch
(3) Lock nut
(4) Adjusting nut
(5) Equalizer
(6) Bracket
C: CAUTION
S404001A03
¼ Wear working clothing, including a cap, protec-
tive goggles, and protective shoes during opera-
tion.
¼ Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
¼ Keep the disassembled parts in order and pro-
tect them from dust or dirt.
¼ Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary
removal, installation, disassembly, and replace-
ment.
¼ Be careful not to burn your hands, because each
part on the vehicle is hot after running.
¼ Use SUBARU genuine grease etc. or the
equivalent. Do not mix grease etc. with that of
another grade or from other manufacturers.
¼ Be sure to tighten fasteners including bolts and
nuts to the specified torque.
¼ Place shop jacks or safety stands at the speci-
fied points.
GENERAL DESCRIPTION
S404001A0502
(7) Clamp
(8) Parking brake cable RH
(9) Clamp (Rear disc brake model
only)
(10) Parking brake cable LH
¼ Apply grease onto sliding or revolution surfaces
before installation.
¼ Before installing O-rings or snap rings, apply
sufficient amount of grease to avoid damage and
deformation.
¼ Before securing a part on a vise, place cushion-
ing material such as wood blocks, aluminum plate,
or shop cloth between the part and the vise.
¼ Keep grease etc. away from parking brake
shoes.
PB-3
Parking Brake
Tightening torque: N·m (kgf-m, ft-lb)
5.9 (0.60, 4.3)
T1:
18 (1.8, 13.0)
T2:
T3: 32 (3.3, 24)
B4M1975A