Subaru Legacy 2002 Service Manual page 2284

10) Disassemble oil pump and bracket by insert-
ing a screwdriver as shown in the figure.
2. 3.0 L MODEL
S601070A1802
1) Remove ground cable from battery.
2) Remove pulley belt cover.
3) Remove V-belt.
4) Disconnect connector from power steering
pressure switch.
5) Remove tensioner adjuster.
6) Disconnect pressure hose and suction hose
from oil pump.
CAUTION:
¼ Do not allow fluid from the hose end to come
into contact with pulley belt.
¼ To prevent foreign matter from entering the
hose, cover the open ends of them with a clean
cloth.
(1) Pressure hose
(2) Suction hose
7) Remove bolts, which install power steering
pump bracket.
OIL PUMP
8) Place oil pump bracket in a vise, remove two
bolts from the front side of oil pump.
CAUTION:
Do not place oil pump bracket directly in the
vise; use soft pads and hold oil pump lightly to
protect the pump.
B4M1661
9) Remove bolt from the rear side of oil pump.
10) Remove oil pump from bracket.
B4M2435A
PS-75
Power Assisted System (Power Steering)
B4M2437
B4M2532