Subaru Legacy 2002 Service Manual page 2318

2. READ CURRENT DATA
1) On the Main Menu
2) On the System Selection Menu
YES key.
3) Press the YES key after displayed the information of ABS type.
4) On the Brake Control Diagnosis
the YES key.
5) On the Data Display Menu
6) Using the scroll key, move the display screen up or down until the desired data is shown.
¼ A list of the support data is shown in the following table.
Display screen
FR Wheel Speed
FL Wheel Speed
RR Wheel Speed
RL Wheel Speed
Stop Light Switch
Stop Light Switch
G sensor output Signal
Valve Relay Signal
Motor Relay Signal
ABS Signal to TCM
ABS Warning Lamp
Motor Relay Monitor
Valve Relay Monitor
CCM Signal
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
3. CLEAR MEMORY MODE
1) On the Main Menu
2) On the System Select Menu
3) Press the YES key after displayed the information of ABS type.
4) On the Brake Control Diagnosis
key.
5) When the "Done" and "turn ignition switch OFF" are shown on the display screen, turn the Subaru Select
Monitor and ignition switch to OFF.
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
SUBARU SELECT MONITOR
S006503A1602
display screen, select the {Each System Check} and press the
display screen, select the {Brake Control System} and press the
display screen, select the {Current Data Display & Save} and press
display screen, select the {Data Display} and press the
Contents to be monitored
Wheel speed detected by the Front Right ABS sensor is dis-
played
Wheel speed detected by the Front Left ABS sensor is dis-
played
Wheel speed detected by the Rear Right ABS sensor is dis-
played
Wheel speed detected by the Rear Left ABS sensor is dis-
played
Stop light switch signal
Stop light switch monitor voltage is displayed.
Refers to vehicle acceleration detecting by the analog G sensor.
It appears on the select monitor display in volts.
Valve Relay Signal
Motor Relay Signal
ABS operation signal from ABS control module to TCM
ON operation of the ABS warning light is displayed.
Operating condition of the motor relay is displayed.
Operating condition of the valve relay is displayed.
ABS operation signal from ABS control module to TCM
S006503A1603
display screen, select the {2. Each System Check} and press the
display screen, select {Brake System} and press the
display screen, select the {Clear Memory} and press the
ABS-17
ABS (Diagnostics)
YES key.
YES key.
Unit of measure
km/h or MPH
km/h or MPH
km/h or MPH
km/h or MPH
ON or OFF
V
V
ON or OFF
ON or OFF
ON or OFF
ON or OFF
High or Low
ON or OFF
ON or OFF
YES key.
YES key.
YES