Manual Transmission and Differential
2. CROSSMEMBER AND CUSHION
RUBBER
S503233A1102
1) Install the rear cushion rubber.
Tightening torque:
35 N·m (3.6 kgf-m, 26 ft-lb)
2) Install the rear crossmember.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
3) Remove the transmission jack.
4) Install the heat shield cover.
5) Install the front, center, rear exhaust pipes and
the muffler.
Without OBD
<Ref. to EX(w/oOBD)-10, INSTALLATION, Front
Exhaust
Pipe.>,
<Ref.
INSTALLATION, Rear Exhaust Pipe.> and <Ref. to
EX(w/oOBD)-14, INSTALLATION, Muffler.>
With OBD
<Ref. to EX-6, INSTALLATION, Front Exhaust
Pipe.>, <Ref. to EX-9, INSTALLATION, Rear
Exhaust
Pipe.>
and
INSTALLATION, Muffler.>
C: INSPECTION
Repair or replace parts if the results of the inspec-
tion below are not satisfactory.
1. PITCHING STOPPER
Make sure that the pitching stopper is not bent or
damaged. Make sure that the rubber is not stiff,
cracked, or otherwise damaged.
2. CROSSMEMBER AND CUSHION
RUBBER
S503233A1002
Make sure that the crossmember is not bent or
damaged. Make sure that the cushion rubber is not
stiff, cracked, or otherwise damaged.
TRANSMISSION MOUNTING SYSTEM
G2M0832
to
EX(w/oOBD)-13,
<Ref.
to
EX-10,
S503233A10
S503233A1001
MT-38