Transmission Case - Subaru Legacy 2002 Service Manual

Manual Transmission and Differential

14. Transmission Case

A: REMOVAL
S503266A18
1. SINGLE-RANGE
1) Remove the manual transmission assembly
from vehicle. <Ref. to MT-31, REMOVAL, Manual
Transmission Assembly.>
2) Remove clutch release lever. <Ref. to CL-19,
REMOVAL, Release Bearing and Lever.>
3) Remove transfer case with extension case
assembly. <Ref. to MT-44, REMOVAL, Transfer
Case and Extension Case Assembly.>
4) Remove bearing mounting bolts.
5) Remove main shaft rear plate.
(A) Main shaft rear plate
6) Put vinyl tape around splines of right and left
axle drive shafts to prevent damage to oil seal.
(A) Vinyl tape
TRANSMISSION CASE
S503266
S503266A1801
S3M0099
S3M0100C
B3M1405B
7) Separate transmission case into right and left
cases by loosening coupling bolts and nuts.
8) Remove drive pinion shaft assembly from left
side transmission case.
NOTE:
Use a hammer handle, etc. to remove if too tight.
(A) Main shaft assembly
(B) Drive pinion shaft assembly
9) Remove main shaft assembly.
10) Remove differential assembly.
NOTE:
¼ Be careful not to confuse right and left roller
bearing outer races.
¼ Be careful not to damage retainer oil seal.
MT-56
B3M1359
B3M0101H
G3M0557