Subaru Legacy 2002 Service Manual page 1947

Rear Suspension
9) Install support sub frame front.
NOTE:
Check wheel alignment and adjust if necessary.
Tightening torque:
Refer to COMPONENT of General
Description for tightening torque. <Ref. to
RS-3, REAR SUSPENSION, COMPONENT,
General Description.>
REAR ARM
C: DISASSEMBLY
1. FRONT BUSHING
1) Using ST-A, B, press front bushing out of place.
ST-A, B 20099AE020 INSTALLER &
(1) Set ST-A in position with larger inside diam-
eter side facing up.
(2) Set rear arm with protruded bushing side
facing down.
(3) Place ST-B on upper side of bushing, then
press bushing out of position.
2. REAR BUSHING
Using ST-C and bearing puller, press rear bushing
out of place.
ST-C 20099AE040 INSTALLER & REMOVER
(1) Bearing puller
RS-12
S201105A06
S201105A0601
REMOVER SET
B4M1800A
S201105A0602
SET
B4M1801B