Transmission Mounting System - Subaru Legacy 2002 Service Manual

Automatic Transmission
10. Transmission Mounting
System
S502233
A: REMOVAL
S502233A18
1. PITCHING STOPPER
1) Disconnect battery ground cable.
2) Remove the air cleaner case or air intake
chamber.
Except 3.0 L model
<Ref. to IN-6, REMOVAL, Air Cleaner Case.>
3.0 L model
<Ref. to IN(H6)-6, REMOVAL, Air Intake Cham-
ber.>
3) Remove the pitching stopper.
2. CROSSMEMBER AND CUSHION
RUBBER
S502233A1802
1) Disconnect battery ground cable.
2) Jack-up vehicle and support it with sturdy
racks.
3) Remove the front, center, rear exhaust pipes
and muffler.
Except 3.0 L model
<Ref. to EX(w/oOBD)-9,
Exhaust Pipe.>, <Ref.
REMOVAL, Rear Exhaust Pipe.> and <Ref. to
EX(w/oOBD)-14, REMOVAL, Muffler.> or <Ref. to
EX-5, REMOVAL, Front Exhaust Pipe.>, <Ref. to
EX-9, REMOVAL, Rear Exhaust Pipe.> and <Ref.
to EX-10, REMOVAL, Muffler.>
3.0 L model
<Ref. to EX(H6)-5, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(H6)-8, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H6)-9, REMOVAL,
Muffler.>
4) Remove the heat shield cover.

TRANSMISSION MOUNTING SYSTEM

S502233A1801
H3M1839
REMOVAL, Front
to EX(w/oOBD)-13,
AT-26
5) Set the transmission jack under the transmis-
sion.
CAUTION:
Make sure that the support plates of transmis-
sion jack don't touch the oil pan.
6) Remove the transmission rear crossmember.
7) Remove the rear cushion rubber.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
B3M1605
B2M3407
S502233A11
S502233A1101
H3M1839A