Subaru Legacy 2002 Service Manual page 1602

12) Remove inhibitor switch from transmission.
(A) Inhibitor switch
13) Disconnect inhibitor switch harness connector
from inhibitor switch.
D: INSTALLATION
1) Connect inhibitor switch harness connector to
inhibitor switch.
2) Install inhibitor switch to transmission case.
(A) Inhibitor switch
3) Move range select lever to neutral position.
4) Using ST, tighten bolts of inhibitor switch.
ST 499267300 STOPPER PIN
Tightening torque:
3.5 N·m (0.36 kgf-m, 2.6 ft-lb)
(A) Inhibitor switch
(B) Range select lever
INHIBITOR SWITCH
B3M1033B
S502243A11
B3M1033B
B3M1034B
AT-31
5) Install select cable to range select lever.
6) Install plate assembly to transmission.
Tightening torque:
T: 24.5 N·m (2.50 kgf-m, 18.1 ft-lb)
(A) Select cable
(B) Plate ASSY
7) Install snap pin to range select lever.
(A) Snap ring
(B) Select cable
(C) Range select lever
Automatic Transmission
B3M1030I
B3M1029C