Parking Brake Assembly - Subaru Legacy 2002 Service Manual

4. Parking Brake Assembly

A: REMOVAL
S404169A18
1) Remove the two mounting bolts and remove
the disc brake assembly.
2) Suspend the disc brake assembly so that the
hose is not stretched.
3) Pull down and release parking brake.
4) Remove the disc rotor.
NOTE:
If the disc rotor is difficult to remove, try the follow-
ing two methods in order.
(1) Turn adjusting screw using a slot-type
screwdriver until brake shoe gets away enough
from the disc rotor.
(1) Adjusting screw
(2) Cover (rubber)
(3) Slot-type screwdriver
(4) Back plate
PARKING BRAKE ASSEMBLY
S404169
B4M1710
S4M0463A
PB-7
(2) If disc rotor seizes up within hub, drive disc
rotor out by installing an 8-mm bolt in holes B on
the rotor.
5) Remove shoe return spring from parking brake
assembly.
6) Using a standard screwdriver, remove front
shoe hold-down spring and pin.
7) Remove strut and strut spring.
8) Remove adjuster assembly from parking brake
assembly.
9) Using a standard screwdriver, remove rear
shoe hold-down spring and pin.
10) Remove brake shoe.
11) Remove parking cable from parking lever.
(1) Parking brake cable
(2) Parking brake lever
12) Using a standard screwdriver, raise retainer.
Remove parking lever and washer from brake
shoe.
Parking Brake
G4M0383
B4M1842
B4M1774B