Subaru Legacy 2002 Service Manual page 2094

Hide thumbs Also See for Legacy 2002:

Table of Contents

3) Place a thickness gauge between ABS sensor's

pole piece and tone wheel's tooth face. After stan-

dard clearance is obtained over the entire

perimeter, tighten ABS sensor on housing to speci-

fied torque.

ABS sensor standard clearance:

0.3 — 0.8 mm (0.012 — 0.031 in)

Tightening torque:

32 N·m (3.3 kgf-m, 24 ft-lb)

Check the marks on the harness to make sure

that no distortion exists.

Except OUTBACK

If the clearance is outside specifications, adjust the

gap using spacer (Part No. 26755AA000).

4) After confirmation of the ABS sensor clearance,

connect connector to ABS sensor.

5) Connect connector to battery ground cable.

FRONT ABS SENSOR

C: INSPECTION

1. ABS SENSOR

S401190A1001

1) Check pole piece of ABS sensor for foreign par-

ticles or damage. If necessary, clean pole piece or

replace ABS sensor.

2) Measure ABS sensor resistance.

Terminal No.

If resistance is outside the standard value,

replace ABS sensor with new one.

Check ABS sensor cable for discontinuity. If

necessary, replace with a new one.

2. SENSOR GAP

S401190A1002

1) Measure the distance "A" between ABS sensor

surface and sensor pole face.

1.25±0.25 kΩ

Chapters

Table of Contents