Subaru Legacy 2002 Service Manual page 1692

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
10) Install the rest parts to the rear section of
transmission main shaft.
NOTE:
Align groove in baulk ring with shifting insert.
(A) Needle bearing
(B) 5th drive gear
(C) Baulk ring
(D) 5th-Rev sleeve and hub ASSY
(E) Lock washer
(F) Lock nuts
11) Tighten lock nuts to the specified torque using
ST1 and ST2.
NOTE:
Secure lock nuts in two places after tightening.
ST1 499987003 SOCKET WRENCH
ST2 498937000 TRANSMISSION HOLDER
Tightening torque:
118 N·m (12.0 kgf-m, 86.8 ft-lb)
2. EXCEPT 2.0 L SOHC
1) Assemble each sleeve and hub assembly.
NOTE:
Position open ends of spring 120° apart.
B3M1371A
2) Install 3rd drive gear, outer baulk ring, synchro
cone, inner baulk ring, sleeve and hub assembly
for 3rd needle bearing on transmission main shaft.
NOTE:
Align groove in baulk ring with shifting insert.
(A)
(B)
(C)
(D)
(E)
(F)
MT-67
Manual Transmission and Differential
S503713A0208
3rd needle bearing
3rd drive gear
Inner baulk ring
Synchro cone
Outer baulk ring
Sleeve and hub ASSY
B3M1366A
B3M0837A