Subaru Legacy 2002 Service Manual page 2072

CAUTION:
¼ Use a new axle nut (Olive color).
¼ Always tighten axle nut before installing
wheel on vehicle. If wheel is installed and
comes in contact with ground when axle nut is
loose, wheel bearings may be damaged.
¼ Be sure to tighten axle nut to specified
torque. Do not overtighten it as this may dam-
age wheel bearing.
8) After tightening axle nut, lock it securely.
C: DISASSEMBLY
1) Place alignment marks on shaft and outer race.
2) Remove SFJ boot band and boot.
CAUTION:
Be careful not to damage boot.
3) Remove circlip from SFJ outer race using
screwdriver.
4) Remove SFJ outer race from shaft assembly.
5) Wipe off grease.
FRONT DRIVE SHAFT
S301153A06
B4M0774
B4M0775
B4M0776
DS-27
CAUTION:
The grease is a special grease. Do not confuse
with other greases.
6) Place alignment mark on free ring and trunnion.
7) Remove free ring from trunnion.
CAUTION:
Be careful with the free ring position.
8) Place alignment mark on trunnion and shaft.
9) Remove snap ring and trunnion.
Drive Shaft System
B4M0777
B4M0778
B4M0779