Subaru Legacy 2002 Service Manual page 1693

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
Manual Transmission and Differential
3) Install 4th needle bearing race onto transmis-
sion main shaft using ST1, ST2 and a press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
(A) 4th needle bearing race
4) Install baulk ring, needle bearing, 4th drive gear
and 4th gear thrust washer to transmission main
shaft.
NOTE:
Align baulk ring and gear & hub assembly with key
groove.
(A) Groove
(B) 4th gear side
5) Drive ball bearing onto the rear section of trans-
mission main shaft using ST1, ST2 and a press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
B3M0543D
6) Using ST1 and ST2, install the 5th gear thrust
washer and 5th needle bearing race onto the rear
section of transmission main shaft.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
NOTE:
Face thrust washer in the correct direction.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
S3M0045A
(A)
MT-68
Face this surface to 5th gear side.
B3M0553F
B3M0091D