MAIN SHAFT ASSEMBLY FOR DUAL-RANGE
Manual Transmission and Differential
5) Using ST1, ST2 and a press, remove ball
bearing, synchro cone and baulk ring (Rev).
NOTE:
¼ Replace sleeve and hub with new ones. Do not
attempt to disassemble because they must engage
at
a
specified
point.
disassembled, mark engagement point on splines
beforehand.
¼ Do not reuse ball bearing.
ST1 499757002 INSTALLER
ST2 498077400 SYNCHRO CONE
REMOVER
(A)
Ball bearing
(B)
Synchro cone
(C)
Baulk ring
If
they
should
be
B3M1365A
MT-72
6) Using ST1 and ST2, remove the rest of parts.
NOTE:
Replace sleeve and hub with new ones. Do not
attempt to disassemble because they must engage
at
a
specified
point.
disassembled, marking engagement point on
splines beforehand.
ST1 899864100 REMOVER
ST2 899714110 REMOVER
7) Remove snap ring from main shaft.
ST 899474100 EXPANDER
If
they
should
be
B3M0835A
H3M1432B