Subaru Legacy 2002 Service Manual page 1946

11) Remove bolt securing rear arm to body.
12) Loosen nut securing link front to rear arm.
13) Loosen nut securing link rear to rear arm.
14) Loosen nut securing link upper to rear arm.
15) Remove bolts securing rear arm to links and
remove rear arm.
REAR ARM
B: INSTALLATION
CAUTION:
Discard old self-locking nut and replace with a
new one.
1) Use a transmission jack to support the rear
arm.
2) Install rear arm and temporarily tighten bolts
securing rear arm to links.
3) Install bearing unit.
<Ref. to DS-23, INSTALLATION, Hub Unit Bear-
ing.>
B4M1796
4) Install bolt securing ABS sensor to rear arm.
5) Install bolt securing brake hose to rear arm.
6) Install bolt securing parking brake cable clamp
to rear arm.
7) Place jack (furnished with vehicle) upside down
and position it between link rear and sub frame.
Adjust jack position so rear shock absorber is
aligned with rear arm at their corresponding holes.
Install lower shock absorber bolts.
CAUTION:
Put a cloth between jack and its mating area to
protect link rear and sub frame from scratches.
B4M1797
8) Using transmission jack, support rear arm hori-
B4M2459
zontally and tighten nuts and bolts securing rear
arm, link front, link rear, link upper and shock
absorber.
B4M1799
(1)
(2)
RS-11
S201105A11
Rear arm
Transmission jack
Rear Suspension
B4M1805
B4M1806C