Brake Pipe - Subaru Legacy 2002 Service Manual

BRAKE PIPE

Brake
14. Brake Pipe
S405165
A: REMOVAL
S405165A18
NOTE:
Airbag system wiring harness is routed near the
center brake pipe.
CAUTION:
¼ All airbag system wiring harness and con-
nectors are colored yellow. Do not use electri-
cal test equipment on these circuits.
¼ Be careful not to damage airbag system wir-
ing harness when servicing the center brake
pipe.
¼ When removing the brake pipe, make sure
that it is not bent.
B: INSTALLATION
S405165A11
NOTE:
Airbag system wiring harness is routed near the
center brake pipe.
CAUTION:
¼ All airbag system wiring harness and con-
nectors are colored yellow. Do not use electri-
cal test equipment on these circuits.
¼ Be careful not to damage airbag system wir-
ing harness when servicing the center brake
pipe.
¼ When installing the brake pipe, make sure
that it is not bent.
¼ After installing the brake pipe and hose,
bleed the air.
¼ After installing the brake hose, make sure
that it does not touch the tire or suspension
assembly, etc.
Brake pipe tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
C: INSPECTION
S405165A10
Ensure there are no cracks, breakage, or damage
on pipes. Check joints for fluid leakage. If any
cracks, breakage, damage or leakage is found,
repair or replace pipe.
NOTE:
Use a mirror when inspecting low-visible part or
back side.
BR-47