Subaru Legacy 2002 Service Manual page 1558

4) Remove cap and then extract straight pin.
(A) Straight pin
(B) Select lever lower
5) Remove select lever lower then take away
select lever upper from plate.
(A) Select lever lower
(B) Select lever upper
(C) Plate
D: ASSEMBLY
S501548A02
1) Clean all parts before assembly.
2) Apply grease [NIGTIGHT LYW No. 2 or equiva-
lent] to each parts. <Ref. to CS-3, AT SELECT
LEVER, COMPONENT, General Description.>
3) Assembly is in the reverse order of disassem-
bly.
4) After completion of fitting, transfer select lever
to range "P" — "1", then check whether the indica-
tor and select lever agree, whether the pointer and
position mark agree and what the operating force
is.
E: INSPECTION
1) Inspect removed parts by comparing with new
ones for deformation, damage and wear. Correct
or replace if defective.
2) Confirm the following parts for operating condi-
tion before assembly. Moving condition of the
selector lever upper... it should move smoothly.
SELECT LEVER
B3M1797A
B3M1848A
S501548A10
CS-9
Control Systems