Subaru Legacy 2002 Service Manual page 1598

2) Install the air cleaner case or air intake cham-
ber.
Except 3.0 L model
<Ref. to IN-6, INSTALLATION, Air Cleaner Case.>
3.0 L model
<Ref. to IN(H6)-6, INSTALLATION, Air Intake
Chamber.>
2. CROSSMEMBER AND CUSHION
RUBBER
S502233A1102
1) Install the rear cushion rubber.
Tightening torque:
39 N·m (4.0 kgf-m, 29 ft-lb)
2) Install the crossmember.
Tightening torque:
T1: 35 N·m (3.6 kgf-m, 26 ft-lb)
T2: 70 N·m (7.1 kgf-m, 51 ft-lb)
3) Remove the transmission jack.
4) Install the heat shield cover.
5) Install the front, center, rear exhaust pipes and
the muffler.
Except 3.0 L model
<Ref. to EX(w/oOBD)-10, INSTALLATION, Front
Exhaust Pipe.>, <Ref.
INSTALLATION, Rear Exhaust Pipe.> and <Ref. to
EX(w/oOBD)-14, INSTALLATION, Muffler.> or
<Ref. to EX-6, INSTALLATION, Front Exhaust
Pipe.>, <Ref. to EX-9, INSTALLATION, Rear
Exhaust Pipe.> and
INSTALLATION, Muffler.>
3.0 L model
<Ref. to EX(H6)-6, INSTALLATION, Front Exhaust
Pipe.>, <Ref. to EX(H6)-8, INSTALLATION, Rear
Exhaust Pipe.> and
INSTALLATION, Muffler.>
C: INSPECTION
Repair or replace parts if the results of the inspec-
tion below are not satisfactory.
1. PITCHING STOPPER
Make sure that the pitching stopper is not bent or
damaged. Make sure that the rubber is not stiff,
cracked, or otherwise damaged.
TRANSMISSION MOUNTING SYSTEM
B2M3407A
to EX(w/oOBD)-13,
<Ref. to EX-10,
<Ref. to EX(H6)-9,
S502233A10
S502233A1001
2. CROSSMEMBER AND CUSHION
RUBBER
S502233A1002
Make sure that the crossmember is not bent or
damaged. Make sure that the cushion rubber is not
stiff, cracked, or otherwise damaged.
AT-27
Automatic Transmission