Subaru Legacy 2002 Service Manual page 2126

VDC SEQUENCE CONTROL
VDC
B: SPECIFICATION
S402195A22
1. CONDITIONS FOR COMPLETION OF
VDC SEQUENCE CONTROL
S402195A2201
When the following conditions develop, the VDC
sequence control stops and VDC operation is
returned to the normal control mode.
1) When the speed of at least one wheel reaches
10 km/h (6 MPH).
2) When terminal No. 5 or No. 8 are separated
from diagnosis terminals. (When select monitor is
not used.)
3) When the brake pedal is released during
sequence control and the braking lamp switch is
set to off.
4) When brake pedal is depressed after ignition
key is turned to ON, and before VDC warning light
goes out. (When select monitor is not used.)
5) When brake pedal is not depressed after igni-
tion key is turned to ON, and within 0.5 seconds
after VDC warning light goes out. (When select
monitor is not used.)
6) After completion of the sequence control.
7) When malfunction is detected. (When select
monitor is used.)
VDC-21