Clutch Switch - Subaru Legacy 2002 Service Manual

11. Clutch Switch

A: REMOVAL
S504258A18
1) Remove battery ground terminal.
2) Disconnect connector from clutch switch.
3) Remove clutch switch.
B: INSTALLATION
1) Move clevis pin of the push rod right and left
and hold where it moves smoothly, then measure
stroke of clutch pedal.
Specified clutch pedal full stroke: A
130 — 135 mm (5.12 — 5.31 in)
Tightening torque:
T: 8 N·m (0.8 kgf-m, 5.8 ft-lb)
2) If clutch pedal stroke is out of specification,
adjust the stroke. <Ref. to CL-31, ADJUSTMENT,
Clutch Pedal.>
3) Connect clutch switch connector.
C: INSPECTION
1) If clutch switch does not operate properly (or if
it does not stop at the specified position), replace
with a new one.
Specified position: L
+1.5 +0.059
2 / mm (0.079
0
CLUTCH SWITCH
S504258
S504258A11
B4M1190C
S504258A10
/ in)
0
G4M0327
2) Check clutch switch continuity. If continuity is
not as specified, replace the switch.
(1) Disconnect the clutch switch connector.
(2) Measure the resistance between 1 and 2 of
switch terminal.
Terminals/Specified resistance
When clutch pedal depressed:
1 — 2/Less than 1Ω
Terminals/Specified resistance
When clutch pedal not depressed:
1 — 2/More than 1MΩ
¼ Clutch switch (With cruise control)
CL-33
Clutch System
B2M4122