Front Vehicle Speed Sensor - Subaru Legacy 2002 Service Manual

13. Front Vehicle Speed Sensor

S502709
A: REMOVAL
S502709A18
1) Set up the vehicle on a lift.
2) Disconnect battery ground cable.
3) Remove air cleaner case or air intake chamber.
Except 3.0 L model
<Ref. to IN-6, REMOVAL, Air Cleaner Case.>
3.0 L model
<Ref. to IN(H6)-5, REMOVAL, Air Intake Cham-
ber.>
4) Disconnect transmission connector.
(A) Transmission connector
5) Remove pitching stopper. <Ref. to AT-26,
REMOVAL, Transmission Mounting System.>
6) Remove the transmission connector from stay.
7) Lift-up the vehicle.
8) Clean transmission exterior.
9) Drain ATF completely.
NOTE:
Tighten ATF drain plug after draining ATF.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
FRONT VEHICLE SPEED SENSOR
G6M0095
S3M0039B
AT-33
(A) Oil pan
(B) Drain plug
(C) Differential oil drain plug
10) Remove front, center, exhaust pipes and muf-
fler.
Except 3.0 L model
<Ref. to EX(w/oOBD)-9,
Exhaust Pipe.>, <Ref.
REMOVAL, Rear Exhaust Pipe.> and <Ref. to
EX(w/oOBD)-14, REMOVAL, Muffler.> or <Ref. to
EX-5, REMOVAL, Front Exhaust Pipe.>, <Ref. to
EX-9, REMOVAL, Rear Exhaust Pipe.> and <Ref.
to EX-10, REMOVAL, Muffler.>
3.0 L model
<Ref. to EX(H6)-5, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(H6)-8, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H6)-9, REMOVAL,
Muffler.>
11) Remove the shield cover.
12) Remove the propeller shaft. <Ref. to DS-13,
REMOVAL, Propeller Shaft.>
13) Place transmission jack under transmission.
NOTE:
Make sure that the support plates of transmission
jack don't touch crossmember.
14) Remove the transmission rear crossmember
bolts.
15) Lower the AT jack.
NOTE:
Do not separate the AT jack and transmission.
16) Remove the oil cooler inlet and outlet pipe.
Automatic Transmission
B3M1036B
REMOVAL, Front
to EX(w/oOBD)-13,
B3M2272