Subaru Legacy 2002 Service Manual page 1661

Manual Transmission and Differential
19) Install front, center, rear, exhaust pipe and
muffler.
Without OBD
<Ref. to EX(w/oOBD)-10, INSTALLATION, Front
Exhaust Pipe.>, <Ref.
INSTALLATION, Rear Exhaust Pipe.> and <Ref. to
EX(w/oOBD)-14, INSTALLATION, Muffler.>
With OBD
<Ref. to EX-6, INSTALLATION, Front Exhaust
Pipe.>, <Ref. to EX-9, INSTALLATION, Rear
Exhaust Pipe.> and
INSTALLATION, Muffler.>
20) Install under cover.
21) Install operating cylinder.
Tightening torque:
37 N·m (3.8 kgf-m, 27.5 ft-lb)
22) Connect the following connectors.
(1) Transmission ground terminal
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
(2) Vehicle speed sensor connector
(3) Neutral position switch connector
(4) Back-up light switch connector
(5) High-low switch connector (Dual-range
model)
23) Install air cleaner case stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
24) Install air cleaner case and intake duct. <Ref.
to IN-6, INSTALLATION, Air Cleaner Case.> and
<Ref. to IN-7, INSTALLATION, Air Intake Duct.>
25) Connect battery ground cable.
26) Pour gear oil and check the oil level. <Ref. to
MT-30, Transmission Gear Oil.>
27) Take off vehicle from lift arms.
MANUAL TRANSMISSION ASSEMBLY
to EX(w/oOBD)-13,
<Ref. to EX-10,
B2M1179
MT-36