Subaru Legacy 2002 Service Manual page 2243

Power Assisted System (Power Steering)
7) Using ST and press, remove oil seal and spe-
cial bearing from valve housing.
ST 34099FA120 INSTALLER & REMOVER
SEAL
CAUTION:
¼ Do not apply a force to end surface of valve
housing.
¼ Do not reuse oil seal after removal.
(1) Oil seal
(2) Special bearing
8) Remove snap ring using snap ring pliers.
CAUTION:
¼ Do not reuse removed snap ring.
¼ Be careful not to scratch pinion and valve
assembly.
STEERING GEARBOX [LHD MODEL]
S4M0159B
G4M0147
PS-34
9) Press out bearing together with backing washer
using pipe of I.D. 38.5 to 39.5 mm (1.516 to 1.555
in) and press.
CAUTION:
Do not reuse removed bearing.
(1) Bearing
(2) Backing washer
(3) Oil seal
(4) Pipe
10) Remove oil seal.
CAUTION:
Do not reuse removed oil seal.
D: ASSEMBLY
S601272A02
1. RACK HOUSING ASSEMBLY
CAUTION:
Use only SUBARU genuine grease for gearbox.
Grease:
VALIANT GREASE M2
[Part No. 003608001, net 0.5 kg (1.1 lb)]
1) Force-fit oil seal using ST.
ST 34199AE050 INSTALLER
CAUTION:
Be careful not to damage or scratch cylinder
inner wall.
NOTE:
¼ Apply specified power steering fluid to oil seal.
¼ Pay special attention not to install oil seal in
wrong direction.
S4M0403A
S601272A0201