Subaru Legacy 2002 Service Manual page 1743

Clutch System
C: CAUTION
S504001A03
¼ Wear working clothing, including a cap, protec-
tive goggles, and protective shoes during opera-
tion.
¼ Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
¼ Keep the disassembled parts in order and pro-
tect them from dust or dirt.
¼ Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary
removal, installation, disassembly, and replace-
ment.
¼ Be careful not to burn your hands, because each
part on the vehicle is hot after running.
¼ Use SUBARU genuine fluid, grease etc. or the
equivalent. Do not mix fluid, grease etc. with that
D: PREPARATION TOOL
1. SPECIAL TOOLS
ILLUSTRATION
B2M3853
B2M4112
B2M4213
GENERAL DESCRIPTION
S504001A17
S504001A1701
TOOL NUMBER
498497100 CRANKSHAFT
STOPPER
499747100 CLUTCH DISC
GUIDE
499057000 TORX PLUS
of another grade or from other manufacturers.
¼ Be sure to tighten fasteners including bolts and
nuts to the specified torque.
¼ Place shop jacks or safety stands at the speci-
fied points.
¼ Apply grease onto sliding or revolution surfaces
before installation.
¼ Before installing O-rings or snap rings, apply
sufficient amount of fluid to avoid damage and
deformation.
¼ Before securing a part on a vise, place cushion-
ing material such as wood blocks, aluminum plate,
or shop cloth between the part and the vise.
¼ Keep fluid away from the vehicle body. If any
fluid contacts the vehicle body, immediately flush
the area with water.
DESCRIPTION
Used for stopping rotation of flywheel when
loosening tightening bolt, etc.
Used when removing and installing clutch disc
to flywheel.
Used for removing and installing flywheel (Dual
mass flywheel type).
CL-10
REMARKS