Subaru Legacy 2002 Service Manual page 1698

MAIN SHAFT ASSEMBLY FOR DUAL-RANGE
8) Remove the rest of parts.
(A) Sleeve and hub ASSY
(B) High-low baulk ring
(C) Friction damper
(D) Low input gear
(E) Needle bearing
(F) Input low gear spacer
(G) Ball
D: ASSEMBLY
S503714A02
1. 2.0 L
S503714A0201
1) Assemble when each sleeve and hub assembly
are disassembled.
NOTE:
Position open ends of spring 120° apart.
(A) High-low coupling sleeve
(B) Shifting insert
(C) High-low synchronizer spring
(D) High-low synchronizer hub
(E) Sleeve
(F) Insert key
(G) 3rd-4th synchronizer hub
(H) Sleeve
(I) Insert key
(J) 5th-Rev synchronizer hub
2) Install 3rd drive gear, baulk ring, sleeve and hub
assembly for 3rd-4th needle bearing on transmis-
sion main shaft.
NOTE:
Align groove in baulk ring with shifting insert.
3) Install 4th needle bearing race onto transmis-
sion main shaft using ST1, ST2 and a press.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
S3M0169A
(A)
4) Install baulk ring, needle bearing, 4th drive gear
and 4th gear thrust washer to transmission main
shaft.
NOTE:
Face thrust washer in the correct direction.
S3M0444A
(A)
(B)
MT-73
Manual Transmission and Differential
4th needle bearing race
Groove
4th gear side
B3M0543D
S3M0045A