Subaru Legacy 2002 Service Manual page 1695

Hide thumbs Also See for Legacy 2002:

Table of Contents

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE

Manual Transmission and Differential

4) Baulk ring

Replace the ring in the following cases:

¼ When the inner surface and end face are dam-

¼ When the ring inner surface is abnormally or

partially worn down.

¼ When the contact surface of the synchronizer

ring insert is scored or abnormally worn down.

5) Shifting insert key

Replace the insert if deformed, excessively worn,

or defective in any way.

Replace the oil seal if the lip is deformed,

hardened, damaged, worn, or defective in any way.

Replace the O-ring if the sealing face is deformed,

hardened, damaged, worn, or defective in any way.

8) Gearshift mechanism

Repair or replace the gearshift mechanism if

excessively worn, bent, or defective in any way.

F: ADJUSTMENT

Selection of main shaft rear plate

Using ST, measure the amount (A) of ball bearing

protrusion from transmission main case surface

and select the proper plate in the following table:

Before measuring, tap the end of main shaft with

a plastic hammer lightly in order to make the clear-

ance zero between the main case surface and the

moving flange of bearing.

ST 498147000 DEPTH GAUGE

Dimension (A)

Chapters

Table of Contents