Subaru Legacy 2002 Service Manual page 2098

Tightening torque:
32 N·m (3.3 kgf-m, 24 ft-lb)
4) Place a thickness gauge between ABS sensor's
and tone wheel's tooth face. After standard clear-
ance is obtained over the entire perimeter, tighten
ABS sensor on rear arm to specified torque.
ABS sensor standard clearance:
0.44 — 0.94 mm (0.0173 — 0.0370 in)
Tightening torque:
32 N·m (3.3 kgf-m, 24 ft-lb)
CAUTION:
Check the marks on the harness to make sure
that no distortion exists.
Mark Yellow
NOTE:
If the clearance is outside specifications, adjust the
gap using spacer (Part No. 26755AA000).
REAR ABS SENSOR
B4M1762
B4M1761
LH RH
White
5) After confirmation of the ABS sensor clearance,
connect connector to ABS sensor and install fuel
tank cover.
6) Connect connector to battery ground cable.
ABS-17
ABS
B4M1760