Subaru Legacy 2002 Service Manual page 1615

SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
Automatic Transmission
B: INSTALLATION
1) Install solenoids and ATF temperature sensor.
Tightening torque:
T: 8 N·m (0.8 kgf-m, 5.8 ft-lb)
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
2) Connect harness connectors.
Connect connectors of same color, and secure
connectors to valve body using clips.
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
S502227A11
B3M1039B
B2M2263J
AT-44
3) Apply proper amount of liquid gasket to the
entire oil pan mating surface.
Fluid packing:
THREE BOND 1217B
4) Apply liquid gasket fully to 3 holes other than
screw holes on the transmission case.
Fluid packing:
THREE BOND 1217B
5) Install oil pan.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
(A) Oil pan
(B) Drain plug
6) Fill ATF up to the middle of the "COLD" side on
level gauge by using the gauge hole. <Ref. to AT-9,
Automatic Transmission Fluid.>
7) Check the ATF level. <Ref. to AT-9, Automatic
Transmission Fluid.>
B3M1040
B3M2265
B3M1036C