Subaru Legacy 2002 Service Manual page 2265

Power Assisted System (Power Steering)
3) Using ST·B and ST·C, attach oil seal to ST·A.
Insert ST·A into rack from gear side. Remove oil
seal from ST·A when it approaches piston and
remove STs from rack.
ST 927490000 INSTALLER; A·B·C
NOTE:
Face oil seal in the direction shown in figure.
(1) Oil seal
(2) Rack
4) Install back-up ring from gear side of rack.
(1) Oil seal
(2) Back-up ring
(3) Rack
STEERING GEARBOX [RHD MODEL]
S4M0427A
S4M0428A
PS-56
5) Install ST on rack and equally apply a thin coat
of grease to rack and ST, then install oil seal.
ST 926250000 GUIDE
CAUTION:
Be careful not to scratch oil seal lips with pis-
ton's knurl section.
(1) Rack piston inner ring
(2) Outer side oil seal
(3) Rack
6) Apply a coat of grease to grooves in rack, slid-
ing surface of sleeve and sealing surface of piston.
Install ST on the end of steering body cylinder.
Then insert rack into steering body from cylinder
side.
ST 34199AE000 GUIDE (Oil seal)
CAUTION:
¼ Be sure to apply grease so that it covers the
entire surface of rack gear teeth.
¼ Do not allow grease to block air vent hole on
rack.
(1) Cylinder side of steering body
(2) Air vent hole
(3) Oil seal
(4) Rack
S4M0429A
S4M0430A