Clutch Pipe And Hose - Subaru Legacy 2002 Service Manual

Hide thumbs Also See for Legacy 2002:

Table of Contents

Clutch System

7. Clutch Pipe and Hose

1) Remove air cleaner case and air intake duct.

2) Drain clutch fluid. <Ref. to CL-25, Clutch Fluid.>

3) Remove clutch pipe from the clutch hose and

master cylinder.

4) Pull out clamp, then remove clutch hose from

5) Remove hose from operating cylinder.

CLUTCH PIPE AND HOSE

B: INSTALLATION

Install in the reverse order of removal.

Bleed clutch fluid. <Ref. to CL-26, Clutch Fluid Air

Tightening torque:

C: INSPECTION

Check pipes and hoses for cracks, breakage, or

damage. Check joints for fluid leakage. If any

cracks, breakage, damage, or leakage is found,

repair or replace the applicable pipe or hose.

T1: 15 N·m (1.5 kgf-m, 10.8 ft-lb)

T2: 18 N·m (1.8 kgf-m, 13.0 ft-lb)

Clutch pipe (LHD model)

Clutch pipe (RHD model)

Table of Contents