Subaru Legacy 2002 Service Manual page 2063

Drive Shaft System
B: INSTALLATION
1) While aligning alignment mark on camber
adjusting bolt head, connect housing and strut.
CAUTION:
Use a new self-locking nut.
Tightening torque:
177 N·m (18.0 kgf-m, 130 ft-lb)
2) Install front drive shaft. <Ref. to DS-26,
INSTALLATION, Front Drive Shaft.>
3) Install transverse link ball joint to housing.
Tightening torque:
49 N·m (5.0 kgf-m, 36 ft-lb)
4) Install ABS sensor harness on strut.
5) Install ABS sensor on housing.
Tightening torque:
32 N·m (3.3 kgf-m, 23.9 ft-lb)
6) Install disc rotor on hub.
7) Install disc brake caliper on housing.
Tightening torque:
78 N·m (8 kgf-m, 57.9 ft-lb)
8) Connect stabilizer link.
9) Connect tie-rod end ball joint and knuckle arm
with a castle nut, and insert cotter pin into tie-rod
end.
Tightening torque:
27.0 N·m (2.75 kgf-m, 19.9 ft-lb)
(A) Cotter pin
(B) Castle nut
(C) Tie-rod
10) While depressing brake pedal, tighten axle nut
and lock it securely.
Tightening torque:
216 N·m (22 kgf-m, 159 ft-lb)
FRONT AXLE
S301148A11
B4M2214A
DS-18
CAUTION:
¼ Use a new axle nut (Olive color).
¼ Always tighten axle nut before installing
wheel on vehicle. If wheel is installed and
comes in contact with ground when axle nut is
loose, wheel bearings may be damaged.
¼ Be sure to tighten axle nut to specified
torque. Do not overtighten it as this may dam-
age wheel bearing.
11) After tightening axle nut, lock it securely.
12) Install wheel and tighten wheel nuts to speci-
fied torque.
Tightening torque:
88 N·m (9 kgf-m, 65 ft-lb)
C: DISASSEMBLY
1) Using ST1, support housing and hub securely.
2) Attach ST2 to housing and drive hub out.
ST1 927060000 HUB REMOVER
ST2 927080000 HUB STAND
G4M0238
S301148A06
G4M0223