Subaru Legacy 2002 Service Manual page 1712

6) After installing key on driven shaft, install 3rd-
4th driven gear using ST and press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
NOTE:
Align groove in baulk ring with insert.
ST 499277200 INSTALLER
7) Install a set of roller bearings onto the driven
shaft using ST and press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
ST 499277200 INSTALLER
DRIVE PINION SHAFT ASSEMBLY
G3M0615
G3M0616
MT-87
Manual Transmission and Differential
8) Position woodruff key in groove on the rear of
driven shaft. Install 5th driven gear onto drive shaft
using ST and press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
ST 499277200 INSTALLER
9) Install lock washer. Install lock nut and tighten
to the specified torque using ST.
ST 499987300 SOCKET WRENCH (50)
Tightening torque:
265 N·m (27 kgf-m, 195 ft-lb)
NOTE:
¼ Stake lock nut at two points.
¼ Using spring balancer, check that starting torque
of roller bearing is 0.1 to 1.5 N (0.01 to 0.15 kgf,
0.02 to 0.33ft).
G3M0617
G3M0618
B3M0079