Subaru Legacy 2002 Service Manual page 1679

Manual Transmission and Differential
2) Remove reverse check plate, reverse check
spring, reverse check cam, return spring (5th-Rev),
reverse accent shaft, return spring cap and return
spring (1st-2nd).
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
3) Remove O-ring.
NOTE:
¼ Reverse check sleeve assembly uses an O-ring
which should not be scratched.
¼ Be careful not to break adjustment shim placed
between reverse check sleeve assembly and case.
D: ASSEMBLY
S503267A02
1) Install return spring (1st-2nd), return spring cap,
reverse accent shaft, check cam, return spring and
check spring onto reverse check sleeve.
NOTE:
Be sure the bent section of reverse check spring is
positioned in the groove in check cam.
(A) Reverse check sleeve
(B) Return spring (1st-2nd)
(C) Return spring cap
(D) Reverse accent shaft
(E) Return spring (5th-Rev)
(F) Reverse check cam
(G) Reverse check spring
REVERSE CHECK SLEEVE
2) Hook the bent section of reverse check spring
over reverse check plate.
3) Rotate cam so that the protrusion of reverse
check cam is at the opening in plate.
4) With cam held in that position, install plate onto
reverse check sleeve and hold with snap ring.
5) Position O-ring in groove in sleeve.
E: INSPECTION
¼ Make sure the cutout section of reverse accent
shaft is aligned with the opening in reverse check
sleeve.
¼ Spin cam by hand for smooth rotation.
¼ Move cam and shaft all the way toward plate
B3M1384A
and release.
If cam does not return properly, replace reverse
check spring; if shaft does not, check for scratches
on the inner surface of sleeve. If sleeve is in good
order, replace spring.
¼ Select a suitable reverse accent shaft and
reverse
ADJUSTMENT, Reverse Check Sleeve.>
B3M1388A
MT-54
S503267A10
(A) Snap ring
(B) Reverse check plate
(C) Check spring
(D) Check cam
check plate.
B3M0048D
<Ref. to MT-55,