Subaru Legacy 2002 Service Manual page 2064

If inner bearing race remains in the hub, remove it
with a suitable tool (commercially available).
CAUTION:
¼ Be careful not to scratch polished area of
hub.
¼ Be sure to install inner race on the side of
outer race from which it was removed.
3) Remove disc cover from housing.
4) Using a standard screwdriver, remove outer
and inner oil seals.
CAUTION:
Do not use old oil seals.
5) Using flat-bladed screwdriver, remove snap
ring.
FRONT AXLE
6) Using ST1, support housing securely.
7) Using ST2, press inner race to drive out outer
bearing.
ST1 927400000 HOUSING STAND
ST2 927100000 BEARING REMOVER
CAUTION:
¼ Do not remove outer race unless it is faulty.
¼ Discard outer race after removal.
¼ Do not replace inner or outer race sepa-
rately; always replace as a unit.
G4M0224
8) Using ST and a hydraulic press, drive hub bolts
out.
ST 927080000 HUB STAND
CAUTION:
Be careful not to hammer hub bolts. This may
deform hub.
G4M0225
D: ASSEMBLY
1) Attach hub to ST securely.
ST 927080000 HUB STAND
H4M1001
DS-19
Drive Shaft System
G4M0227
G4M0228
S301148A02
G4M0230