Subaru Legacy 2002 Service Manual page 1560

B: INSTALLATION
1) Install select cable to plate assembly.
Tightening torque:
32 N·m (3.3 kgf-m, 24 ft-lb)
2) Install select cable to range select lever.
3) Install plate assembly to transmission.
Tightening torque:
T: 24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
(A) Select cable
(B) Plate ASSY
4) Install washer and snap pin to range select
lever.
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Clamp
(E) Washer
5) Insert the thread portion of the other inner cable
and into the connector hole of the select lever, and
fix the other outer cable end to the bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13 ft-lb)
6) Move the select lever to the "N" position, then
adjust the select cable position. <Ref. to CS-11,
ADJUSTMENT, Select Cable.>
SELECT CABLE
S501549A11
B3M1030G
B3M1029D
CS-11
7) Install heat shield cover.
8) Install front, center, rear exhaust pipe and muf-
fler.
Except 3.0 L model
<Ref. to EX(w/oOBD)-10, INSTALLATION, Front
Exhaust Pipe.>, <Ref.
INSTALLATION, Rear Exhaust Pipe.> and <Ref. to
EX(w/oOBD)-14, INSTALLATION, Muffler.> or
<Ref. to EX-6, INSTALLATION, Front Exhaust
Pipe.>, <Ref. to EX-9, INSTALLATION, Rear
Exhaust Pipe.> and
INSTALLATION, Muffler.>
3.0 L model
<Ref. to EX(H6)-6, INSTALLATION, Front Exhaust
Pipe.>, <Ref. to EX(H6)-8, INSTALLATION, Rear
Exhaust Pipe.> and
INSTALLATION, Muffler.>
C: INSPECTION
Check the removed cable and replace if damaged,
rusty, or malfunctioning.
1) Check for smooth operation of the cable.
2) Check the inner cable for damage and rust.
3) Check the outer cable for damage, bends, and
cracks.
4) Check the boot for damage, cracks, and dete-
rioration.
5) Move select lever from "P" position to "1" posi-
tion. You should be able to feel the detentes in
each position. If the detentes cannot be felt or the
position pointer is improperly aligned, adjust the
cable.
D: ADJUSTMENT
1) Prior to removal, set lever to "N" position.
2) Remove rear exhaust pipe and muffler.
Except 3.0 L model
<Ref. to EX(w/oOBD)-13,
Exhaust Pipe.> and <Ref. to EX(w/oOBD)-14,
REMOVAL, Muffler.> or <Ref. to EX-9, REMOVAL,
Rear Exhaust Pipe.> and <Ref. to EX-10,
REMOVAL, Muffler.>
Control Systems
B3M1605
to EX(w/oOBD)-13,
<Ref. to EX-10,
<Ref. to EX(H6)-9,
S501549A10
S501549A01
REMOVAL, Rear