Subaru Legacy 2002 Service Manual page 1561

Control Systems
3.0 L model
<Ref. to EX(H6)-5, REMOVAL, Front Exhaust
Pipe.> and <Ref. to EX(H6)-8, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H6)-9, REMOVAL,
Muffler.>
3) Remove heat shield cover.
4) Loosen the adjusting nut on each side.
(A) Adjusting nut A
(B) Adjusting nut B
5) Turn adjusting nut B until it lightly touches the
connector.
(A) Front side
(B) Select lever
(C) Connector
(D) Adjusting nut B
(E) Contact point
(F) Adjusting nut A
SELECT CABLE
6) While preventing adjusting nut B from moving
with a wrench, tighten adjusting nut A.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
(A)
B3M1605
(B)
7) After completion of fitting, make sure that the
select lever operates smoothly all across the oper-
ating range.
8) Install in the reverse order of removal.
B3M1792A
B3M1793A
CS-12
Adjusting nut A
Adjusting nut B
B3M1794A