Subaru Legacy 2002 Service Manual page 1596

<Ref. to EX(w/oOBD)-13, INSTALLATION, Rear
Exhaust Pipe.> and <Ref. to EX(w/oOBD)-14,
INSTALLATION, Muffler.> or <Ref. to EX-9,
INSTALLATION, Rear Exhaust Pipe.> and <Ref. to
EX-10, INSTALLATION, Muffler.>
3.0 L model
<Ref. to EX(H6)-8, INSTALLATION, Rear Exhaust
Pipe.> and <Ref. to EX(H6)-9, INSTALLATION,
Muffler.>
20) Install front and center exhaust pipe.
Except 3.0 L model
<Ref. to EX(w/oOBD)-10, INSTALLATION, Front
Exhaust Pipe.> or <Ref. to EX-6, INSTALLATION,
Front Exhaust Pipe.>
3.0 L model
<Ref. to EX(H6)-6, INSTALLATION, Front Exhaust
Pipe.>
21) Install under cover.
22) Lower the vehicle.
23) Install ATF level gauge.
24) Connect the following connectors.
(1) Transmission harness connectors
(2) Transmission ground terminal
25) Connect the following cables.
(1) Cruise control cable (With cruise control
vehicles)
26) Install air cleaner case stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
27) Install air cleaner case or air intake chamber.
Except 3.0 L model
<Ref. to IN-6, INSTALLATION, Air Cleaner Case.>
3.0 L model
<Ref. to IN(H6)-6, INSTALLATION, Air Intake
Chamber.>
28) Connect battery ground cable.
29) Fill ATF up to the middle of the "COLD" side on
level gauge by using the gauge hole. <Ref. to AT-9,
Automatic Transmission Fluid.>
30) Take off vehicle from lift arms.
31) Check select lever operation.
<Ref. to AT-29, INSPECTION, Inhibitor Switch.>
32) Check the ATF level. <Ref. to AT-9, Automatic
Transmission Fluid.>
AUTOMATIC TRANSMISSION ASSEMBLY
S2M0214
33) Check the vehicle on the road tester.
<Ref. to AT-12, Road Test.>
AT-25
Automatic Transmission